config(D2pccard)
config --
initialize a loadable kernel module
Syntax
See
config(D2)
for syntax and general usage information
about this entry point routine.
Usage
PC Card client-enabled drivers
code the following subfunctions to the
config( )
entry point routine:
CFG_ADD-
CFG_VERIFY-
See
_verify(D2pccard)
for information.
CFG_SUSPEND-
Put the specified card in suspend mode
by turning off some power to the hardware.
CFG_REMOVE-
Version applicability
pccard:
2 with ddi: 8
Differences between versions
For Release 7.1,
the DDI 8 interface for
PC Card client-enabled drivers
has not been fully tested and implemented.
Specifically, the CFG_SUSPEND, CFG_RESUME,
and CFG_MODIFY subfunctions
are disabled for Release 7.1.G
This page provides as much as we know about the implementation
but the information may change.
SVR5 and SCO OpenServer 5 compatibility
SCO OpenServer 5 PC Card devices
implement the
config( )
information in their
init(D2pccard)
entry point routines.
References
config(D2),
config(D2mdi),
config(D2sdi),
init(D2pccard),
_verify(D2pccard)
19 June 2005
© 2005 The SCO Group, Inc. All rights reserved.
OpenServer 6 and UnixWare (SVR5) HDK - June 2005